Brocade Communications Systems 8 Reference page 110

2
AG-1034
Severity INFO
AG-1034
Message
<timestamp>, [AG-1034], <sequence-number>,, INFO, <system-name>,F_Port cannot
accept any more logins (<fport>) .
Probable Cause Indicates that the F_Port has already logged in the maximum number of devices.
Recommended No action is required.
Action
Severity INFO
AG-1035
Message
<timestamp>, [AG-1035], <sequence-number>,, INFO, <system-name>,Device cannot
login as ALPA value not available (<alpa>) .
Probable Cause Indicates that a device has already used this ALPA value.
Recommended No action is required.
Action
Severity INFO
AG-1036
Message
<timestamp>, [AG-1036], <sequence-number>,, WARNING, <system-name>,Port <port> is
connected to a Non-Brocade fabric with Persistent ALPA enabled. Check the admin
guide for supported configuration .
Probable Cause Indicates that one of the ports is connected to a non-Brocade fabric.
Recommended No action is required.
Action
Severity WARNING
AG-1037
Message
<timestamp>, [AG-1037], <sequence-number>,, INFO, <system-name>,Trunked N_Port
(<nport>) going offline, if switchshow CLI for the connected fabric switch port
displays Persistently disabled: Area has been acquired, then check cabling: all
trunked ports should be in same ASIC Port Group .
Probable Cause Indicates that the cabling is incorrect.
34 Fabric OS Message Reference
53-1001767-01