Brocade Communications Systems 8 Reference page 585

Fabric os message reference

Hide thumbs Also See for 8:

Table of Contents

Probable Cause

Indicates there has been a corruption during the distribution of the security database. This can only

occur when the primary fabric configuration server (FCS) is distributing the security database to the

other switches in the fabric and local validation finds that there is an error in the security database.

This is a rare occurrence.

Run the secFabricShow command to verify that the fabric is still consistent. All the switches should

be in the ready state. If a switch is in the error state, the database might not be correctly updated

for that specific switch.

<timestamp>, [SEC-1033], <sequence-number>,, ERROR, <system-name>, Invalid

character used in member parameter to add switch to SCC policy; command

Probable Cause

Indicates a member parameter in the secPolicyAdd command is invalid (e. g., it may include an

invalid character, such as an asterisk). A valid switch identifier (a WWN, a domain ID, or a switch

name) must be provided as a member parameter in the secPolicyAdd command. Only the

secPolicyCreate command supports use of the asterisk for adding switches to policies.

Run the secPolicyAdd command using a valid switch identifier (WWN, domain ID, or switch name)

to add specific switches to the switch connection control (SCC) policy.

Refer to the Fabric OS Command Reference for more information on the secPolicyAdd and

secPolicyCreate commands.

<timestamp>, [SEC-1034], <sequence-number>,, ERROR, <system-name>, Invalid member

<policy member>.

Probable Cause

Indicates the input list has an invalid member.

Verify the member names, and input the correct information.

<timestamp>, [SEC-1035], <sequence-number>,, ERROR, <system-name>, Invalid device

Probable Cause

Indicates the specified world wide name (WWN) is invalid.

Enter the correct WWN value.

Fabric OS Message Reference

53-1001767-01

Chapters

Table of Contents