Brocade Communications Systems 8 Reference page 685

SULB-1008
Message
<timestamp>, [SULB-1008], <sequence-number>,, INFO, <system-name>, Standby CP
booted successfully with new firmware.
Probable Cause Indicates the standby CP has rebooted successfully.
Recommended No action is required. The firmwareDownload command is progressing as expected.
Action
Run the firmwareDownloadStatus command for more information.
Severity INFO
SULB-1009
Message
AUDIT, <timestamp>, [SULB-1009], AUDIT, INFO, FIRMWARE,
<event-initiator-details>, <event-location>, , Firmwaredownload command failed.
status: 0x<status code>, error: 0x<error code>.
Probable Cause Indicates the firmwareDownload command failed. The additional status code and error code
provide debugging information.
Table
in this RASLOG message.
TABLE 6
Status Message
"firmwareDownload sanity check failed."
"Sanity check failed because system is non-redundant."
"Sanity check failed because firmwareDownload is already in progress."
"Sanity check failed because FABRIC OS is disabled on Active CP."
"Sanity check failed because HAMD is disabled on Active CP."
"Sanity check failed because firmwareDownload is already in progress."
"Sanity check failed because FABRIC OS is disabled on Standby CP."
"Sanity check failed because HAMD is disabled on Standby CP."
"firmwareDownload failed on Standby CP."
"firmwareDownload failed on Standby CP."
"firmwareDownload failed on Standby CP."
"firmwareCommit failed on Standby CP."
"firmwareDownload failed."
"firmwareDownload failed due to IPC error."
"Unable to check the firmware version on Standby CP due to IPC error."
"firmwareDownload failed due to IPC error."
"firmwareDownload failed due to IPC error."
"Standby CP failed to reboot due to IPC error."
Fabric OS Message Reference
53-1001767-01
lists firmwareDownload status messages and status codes. Some of them will not show up
Status Messages and Status Codes
97
SULB-1008
Status Code
0x30
0x31
0x32
0x33
0x34
0x35
0x36
0x37
0x40
0x41
0x42
0x43
0x44
0x50
0x51
0x52
0x53
0x54
609