Brocade Communications Systems 8 Reference page 420

Fabric os message reference

Hide thumbs Also See for 8:

Table of Contents

Replace the faulty blade.

<timestamp>, [FW-1435], <sequence-number>,, WARNING, <system-name>, Switch status

change contributing factor Flash: usage out of range.

Probable Cause

Indicates that the switch status is not in a healthy state. This occurred because the flash usage is

out of range. The policy was set using the switchStatusPolicySet command.

Run the supportSave command to clear out the kernel flash. Refer to the Fabric OS Command

Reference for more information about this command.

<timestamp>, [FW-1436], <sequence-number>,, WARNING, <system-name>, Switch status

change contributing factor Marginal ports: <Num of marginal ports and the port

numbers> marginal ports. (Ports <Unknown>)

Probable Cause

Indicates that the switch status is not in a healthy state. This occurred because the number of

marginal ports is greater than or equal to the policy set using the switchStatusPolicySet command.

A port is faulty when the port value for Link Loss, Synchronization Loss, Signal Loss, Invalid word,

Protocol error, cyclic redundancy check (CRC) error, Port state change or Buffer Limited Port is

above the high boundary.

Replace any faulty or deteriorating small form-factor pluggables (SFPs).

<timestamp>, [FW-1437], <sequence-number>,, WARNING, <system-name>, Switch status

change contributing factor faulty ports: <Num of faulty ports>. (Ports <unknown>.

Probable Cause

Indicates that the switch status is not in a healthy state. This occurred because the number of

faulty ports is greater than or equal to the policy set by the switchStatusPolicySet command. A port

is considered faulty due to hardware failure such as a faulty small form-factor pluggable (SFP) or

Replace any faulty or deteriorating small form-factor pluggables (SFPs).

Fabric OS Message Reference

53-1001767-01

Chapters

Table of Contents