Brocade Communications Systems 8 Reference page 696

97
SULB-1036
Probable Cause Indicates an error has occurred during the relocation of the internal image. The error may be
caused by inconsistent internal firmware image. It may also be caused by the internal Ethernet or
persistent storage hardware failure.
Recommended Reset the switch. This will cause the internal image to be relocated again. If the problem persists,
Action contact your switch service provider.
Severity ERROR
SULB-1036
Message
<timestamp>, [SULB-1036], <sequence-number>,, INFO, <system-name>, <The Version
being logged><Version String>.
Probable Cause Indicates the firmware version is running in the system. This is generally logged before download
and after download of the firmware to store version information.
Recommended No action is required.
Action
Severity INFO
SULB-1037
Message
<timestamp>, [SULB-1037], <sequence-number>, AUDIT, INFO, <system-name>, HCL
failed. Reboot the switch manually using the reboot command. However, it will
disrupt the FC traffic.
Probable Cause Indicates HCL has failed. Many reasons, such as domain not confirmed, can cause this failure.
Recommended Run the reboot command to reboot the switch manually.
Action
Severity INFO
SULB-1038
Message
<timestamp>, [SULB-1038], WARNING, FIRMWARE, Co-CPU has not booted up properly.
Skip the firmwaredownload command on the co-CPU.
Probable Cause Indicates that the Main CPU cannot access the co-CPU to update the firmware on the co-CPU or run
any other firmwaredownload command on the co-CPU. If firmwareDownload in progress it will
continue without updating the co-CPU firmware.
Recommended After firmwaredownload completes, reboot the CP manually to bring up the co-CPU and run the
Action firmwareDownload command again. If the problem persists, contact the service provider.
Severity WARNING
620 Fabric OS Message Reference
53-1001767-01