Pdm System Messages - Brocade Communications Systems 8 Reference

PDM System Messages

PDM-1001
Message
<timestamp>, [PDM-1001], <sequence-number>,, WARNING, <system-name>, Failed to
parse the pdm config.
Probable Cause Indicates the parity data manager (PDM) process could not parse the configuration file. This might
be caused by a missing configuration file during the installation.
Recommended Run the firmwareDownload command to reinstall the firmware.
Action
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity WARNING
PDM-1002
Message
<timestamp>, [PDM-1002], <sequence-number>,, WARNING, <system-name>, ipcInit
failed.
Probable Cause Indicates the parity data manager (PDM) process could not initialize the inter-process
communication (IPC) mechanism.
Recommended If the message persists, run the supportFtp command (as needed) to set up automatic FTP
Action transfers; then run the supportSave command and contact your switch service provider.
Severity WARNING
PDM-1003
Message
<timestamp>, [PDM-1003], <sequence-number>,, WARNING, <system-name>, pdm [-d] -S
<service> -s <instance>.
Probable Cause Indicates a syntax error occurred when trying to launch the parity data manager (PDM) process.
Recommended Run the firmwareDownload command to reinstall the firmware.
Action
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity WARNING
Fabric OS Message Reference
53-1001767-01
Chapter
75
459