Brocade Communications Systems 8 Reference page 633

Fabric os message reference

Hide thumbs Also See for 8:

Table of Contents

<timestamp>, [SEC-1331], <sequence-number>,, ERROR, <system-name>, Attempt to

enable secure mode failed. Reason: <Reason>.

Probable Cause

Indicates the secModeEnable command failed on the fabric because default IP Filter policies are

not active on the switch, or an active transaction exists on IP Filter policies.

Verify the security event was planned. If the security event was planned, run the ipfilter --activate

default_ipv4 or the ipfilter --activate default_ipv6 command to activate default IP Filter Policies.

Use the ipfilter --save or the ipfilter --transabort commands to save or abort any active

transaction on IP Filter policies. Then retry the secModeEnable command.

<timestamp>, [SEC-1332], <sequence-number>,, ERROR, <system-name>, Fabric wide

policy is conflicting as <Policy Name> is present in the fabric wide policy and

5.3 or 5.2 switches present in the fabric.

Probable Cause

Indicates the fabric-wide policy is conflicting.

Remove either the FCS from the fabric-wide policy, or remove 5.3 and 5.2 switches from the fabric,

or set the fabric-wide mode for FCS as Strict.

<timestamp>, [SEC-1333], <sequence-number>,, INFO, <system-name>, <Name of

command> command failed. There are VF enabled switches in fabric. <List of

databases rejecting distribution> db(s) distribution is blocked.

Probable Cause

Indicates an attempt to distribute PWD or IPFILTER databases from the fabric to a switch that is

If the databases need to be distributed, disable VF on all the switches that have VF enabled. If the

databases do not need to be distributed, no action is required.

<timestamp>, [SEC-3005], <sequence-number>, AUDIT, INFO, <system-name>, Event:

<Event Name>, Status: success, Info: Added member(s) <Members added> to policy

<Policy Name>.

Fabric OS Message Reference

53-1001767-01

Chapters

Table of Contents