Brocade Communications Systems 8 Reference page 310

34
FCR-1076
FCR-1076
Message
<timestamp>, [FCR-1076], <sequence-number>,, ERROR, <system-name>, Port <port
number> disabled, system only supports <maximum fds> front domains.
Probable Cause Indicates that the maximum number of supported front domains was exceeded. To enable the
specified port, disable any other operational front domain and then re-enable the port.
Recommended Make sure to remain within the maximum of supported front domains.
Action
Severity ERROR
FCR-1077
Message
<timestamp>, [FCR-1077], <sequence-number>,, WARNING, <system-name>, Port <port
number> rejected fabric binding request/check from the M-Model switch; <port
number>.
Probable Cause Indicates that an M-Model edge switch attempted to either activate or check the fabric binding.
This port will be disabled if this event occurred during a check of fabric binding and not during
failure to activate fabric binding. The error is caused when the binding list details configured on the
M-Model switch does not match with the currently configured front port domain ID and WWN of the
EX_Port on which this operation was attempted.
Recommended Ensure that the M-Model switch has the same currently configured details such as front port
Action domain ID and WWN of the EX_Port on which this operation was attempted.
Severity WARNING
FCR-1078
Message
<timestamp>, [FCR-1078], <sequence-number>,, WARNING, <system-name>, LSAN name
<LSAN name> is too long. It is dropped.
Probable Cause Indicates that the length of the LSAN name exceeds the limit of 64 characters.
Recommended Change the name and reactivate the zone database.
Action
Severity WARNING
FCR-1079
Message
<timestamp>, [FCR-1079], <sequence-number>,, WARNING, <system-name>, Domain
<Domain> has conflict matrix database with local domain.
Probable Cause Indicates that the specified domain has a different matrix database from the local domain.
234 Fabric OS Message Reference
53-1001767-01