Brocade Communications Systems 8 Reference page 687

TABLE 6
Status Message
"The original firmware has been restored successfully on Standby CP."
"Unable to restore the original firmware on Standby CP."
"Standby CP reboots."
"Standby CP failed to reboot."
"Standby CP booted up with new firmware."
"Standby CP failed to boot up with new firmware."
"There was an unexpected reboot during firmwareDownload. The command is aborted."
"Standby CP was not responding. The command is aborted."
"firmwareCommit has started on both CPs. Please use firmwareDownloadStatus and
firmwareShow to see the firmware status."
"firmwareCommit has started on the local CP. Please use firmwareDownloadStatus and
firmwareShow to see the firmware status."
"firmwareCommit has started on the remote CP. Please use firmwareDownloadStatus and
firmwareShow to see the firmware status."
"Please use firmwareDownloadStatus and firmwareShow to see the firmware status."
"firmwareDownload command has completed successfully."
"The original firmware has been restored successfully."
"Remote CP is restoring its secondary partition."
"Local CP is restoring its secondary partition."
"Remote CP is restoring its secondary partition."
"firmwareDownload has started."
"firmwareCommit has started."
"firmwareDownload has completed successfully."
"firmwareCommit has completed successfully."
"firmwareCommit has started to restore the secondary partition."
"firmwareCommit failed."
"The secondary partition has been restored successfully."
"Firmware is being downloaded to the blade. This step may take up to 10 minutes."
"firmwareDownload timed out."
"Reboot occurred during firmwareDownload. firmwareCommit will be started to recover the
blade."
"Blade rebooted during firmwareCommit. The operation will be restarted."
"Firmware has been downloaded successfully. Blade is rebooting with the new firmware."
"Blade has rebooted successfully."
"New firmware failed to boot up. Please retry firmwareDownload."
"firmwareCommit has started on the blade. This may take up to 10 minutes."
Fabric OS Message Reference
53-1001767-01
Status Messages and Status Codes
97
SULB-1009
Status Code
0x7e
0x7f
0x80
0x81
0x82
0x83
0x84
0x85
0x86
0x87
0x88
0x89
0x8a
0x8b
0x8c
0x8d
0x8e
0x8f
0x90
0x91
0x92
0x93
0x94
0x95
0xa0
0xa1
0xa2
0xa3
0xa4
0xa5
0xa6
0xa7
611