Rcs System Messages - Brocade Communications Systems 8 Reference

RCS System Messages

RCS-1001
Message
<timestamp>, [RCS-1001], <sequence-number>,, INFO, <system-name>, RCS has been
disabled. Some switches in the fabric do not support this feature.
Probable Cause Indicates that the RCS feature has been disabled on the local switch because not all switches in
the fabric support RCS or the switch is in nonnative mode.
Recommended Run the rcsInfoShow command to view RCS capability on the fabric. RCS is supported in Fabric OS
Action v2.6, v3.1 and later, and v4.1 and later.
Run the firmwareDownload command to upgrade the firmware for any switches that do not support
RCS.
Severity INFO
RCS-1002
Message
<timestamp>, [RCS-1002], <sequence-number>,, INFO, <system-name>, RCS has been
enabled.
Probable Cause Indicates that the RCS feature has been enabled. RCS must be capable on all switches in the fabric
to be enabled. If all switches are capable, it is automatically enabled.
Recommended No action is required.
Action
Severity INFO
RCS-1003
Message
<timestamp>, [RCS-1003], <sequence-number>,, ERROR, <system-name>, Failed to
allocate memory: (
Probable Cause Indicates that the specified RCS function failed to allocate memory.
Recommended This message is usually transitory. Wait for a few minutes and retry the command.
Action
Check the memory usage on the switch using the memShow command.
Restart or power cycle the switch.
Severity ERROR
Fabric OS Message Reference
53-1001767-01
<function name>
)
Chapter
83
487