Brocade Communications Systems 8 Reference page 230

22
EM-1016
Severity WARNING
EM-1016
Message
<timestamp>, [EM-1016], <sequence-number>,, WARNING, <system-name>, Cold recovery
failed (
Probable Cause Indicates that a problem was discovered when performing consistency checks during a cold boot.
Recommended Monitor the switch.
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
EM-1017
Message
<timestamp>, [EM-1017], <sequence-number>,, WARNING, <system-name>, Uncommitted
WWN change detected. Cold reboot required.
Probable Cause Indicates that a user did not commit a changed world wide name (WWN) value prior to executing a
reboot, power cycle, or firmwareDownload operation.
Recommended Change and commit the new WWN value.
Action
Severity WARNING
EM-1018
Message
<timestamp>, [EM-1018], <sequence-number>, FFDC, CRITICAL, <system-name>, CP
blade in slot <slot number> failed to retrieve current chassis type (<detailed
fault descriptor>/<PLACE HOLDER>/0x<PLACE HOLDER>).
Probable Cause Indicates that there was a failure to read the chassis type from the system.
Recommended Verify that the control processor (CP) blade is operational and is properly seated in its slot.
Action
Severity CRITICAL
EM-1019
Message
<timestamp>, [EM-1019], <sequence-number>,, WARNING, <system-name>, Current
chassis configuration option (
is not compatible with standby firmware version (Pre 4.4), cannot allow HA Sync.
154
<Return code>
).
<Chassis config option currently in effect>
)
Fabric OS Message Reference
53-1001767-01