Brocade Communications Systems 8 Reference page 821

0x24 - out of disk space. This error may occur because some coredump files have not been
removed from the filesystem and are using up disk space. Remove these coredump files using the
supportSave command before proceeding.
0x29 - The pre-install script failed. This error may be caused by an unsupported blade type in the
chassis. Remove or power off the unsupported blades before proceeding. Another possible cause
may be an invalid chassisConfig option setting. In that case, reset the chassisConfig option before
retrying firmwareDownload.
0x2e - Invalid Red Hat package manager (RPM) package. This error maybe caused by an
inconsistent firmware image loaded on the file server. It may also be caused by temporary
networking issues. Please reload firmware packages on the file server, then retry
firmwareDownload. If the problem persists, contact your system administrator.
Table 11
firmwareDownload process the error occurred.
TABLE 11
Upgrade State
SUS_PEER_CHECK_SANITY
SUS_PEER_FWDL_BEGIN
SUS_SBY_FWDL_BEGIN
SUS_PEER_REBOOT
SUS_SBY_REBOOT
SUS_SBY_FABOS_OK
SUS_PEER_FS_CHECK
SUS_SELF_FAILOVER
SUS_SBY_FWDL1_BEGIN
SUS_SELF_FWDL_BEGIN
SUS_SELF_COMMIT
SUS_SBY_FWC_BEGIN
SUS_SBY_COMMIT
SUS_SBY_FS_CHECK
SUS_ACT_FWC_BEGIN
SUS_PEER_RESTORE_BEGIN
SUS_SBY_RESTORE_BEGIN
SUS_PEER_FWC_BEGIN
SUS_PEER_FS_CHECK1
SUS_FINISH
SUS_COMMIT
Recommended Run the firmwareDownloadStatus command for more information.
Action
In a director-class switch, when firmwareDownload fails, the command will synchronize the
firmware on the two partitions of each CP by starting a firmware commit operation. Wait until this
operation completes (about 10 minutes) before attempting another firmwareDownload.
Fabric OS Message Reference
53-1001767-01
lists the firmwareDownload state names and state values. They indicate where in the
Upgrade State and Code Value
Code
0x21
0x22
0x23
0x24
0x25
0x26
0x27
0x28
0x29
0x2a
0x2b
0x2c
0x2d
0x2e
0x2f
0x30
0x31
0x32
0x33
0x34
0x35
128
SULB-1009
745