Brocade Communications Systems 8 Reference page 584

Fabric os message reference

Hide thumbs Also See for 8:

Table of Contents

<timestamp>, [SEC-1029], <sequence-number>,, ERROR, <system-name>, Invalid

character in <policy name>.

Probable Cause

Indicates a corruption occurred during the distribution of the security database. This can occur only

when the primary fabric configuration server (FCS) distributes the security database to the other

switches in the fabric, then local validation finds the error in the security database. This is a rare

Run the secFabricShow command to verify that the fabric is still consistent. All the switches should

be in the ready state. If a switch is in the error state, the database might not be correctly updated

for that specific switch.

<timestamp>, [SEC-1030], <sequence-number>, ERROR, <system-name>, The length of

the name invalid.

Probable Cause

Indicates a corruption occurred during the distribution of the security database. This can occur only

when the primary fabric configuration server (FCS) distributes the security database to the other

switches in the fabric, then local validation finds the error in the security database. This is a rare

Run the secFabricShow command to verify that the fabric is still consistent. All the switches should

be in the ready state. If a switch is in the error state, the database might not be correctly updated

for that specific switch.

<timestamp>, [SEC-1031], <sequence-number>,, WARNING, <system-name>, Current

security policy DB cannot be supported by standby. CPs will go out of sync.

Probable Cause

Indicates the security database size is not supported by the standby control processor (CP).

Reduce the security policy size by deleting entries within a policy or by deleting some policies.

<timestamp>, [SEC-1032], <sequence-number>,, ERROR, <system-name>, Empty FCS list

is not allowed.

Fabric OS Message Reference

53-1001767-01

Chapters

Table of Contents