Brocade Communications Systems 8 Reference page 480

Fabric os message reference

Hide thumbs Also See for 8:

Table of Contents

Probable Cause

Indicates that configured Port Mode is different from the intended use.

Change the port configuration (by deleting configured FCIP tunnels or iSCSI sessions) to return the

port mode to neutral before attempting to configure the port for a different mode or use.

<timestamp>, [IPS-1005], <sequence-number>,, WARNING, <system-name>, Tunnel

Authorization Failure for slot (<slot>) port(ge<port>) tunnel ID(<tunnel number>)

reason (<reason>)

Probable Cause

Indicates that tunnel setup failed because of an authorization failure from the remote side. A

reason for such a failure could be a WWN mismatch.

Change the tunnel configuration on one side of the tunnel to authorize the remote side to set up

<timestamp>, [IPS-1006], <sequence-number>,, WARNING, <system-name>, Tunnel

Configuration Mismatch for slot (<slot>) port(<port>) tunnel ID(<tunnel number>)

reason (<reason>)

Probable Cause

Indicates that tunnel setup failed because of a configuration mismatch between the two ends. The

reason for such a mismatch could be a Compression setting or WanTOV enforcement.

Change the tunnel configuration on one side of the tunnel to match that of the other side to set up

Fabric OS Message Reference

53-1001767-01

Chapters

Table of Contents