Brocade Communications Systems 8 Reference page 586

90
SEC-1036
Severity ERROR
SEC-1036
Message
<timestamp>, [SEC-1036], <sequence-number>,, ERROR, <system-name>, Device name
<device name>
Probable Cause Indicates one or more device names mentioned in the securePolicyCreate or securePolicyAdd
command does not have the colon character (:) as required.
Recommended Run the secPolicyCreate or secPolicyAdd command with a properly formatted device name
Action parameter.
Severity ERROR
SEC-1037
Message
<timestamp>, [SEC-1037], <sequence-number>,, ERROR, <system-name>, Invalid WWN
format
Probable Cause Indicates the world wide name (WWN) entered in the policy member list had an invalid format.
Recommended Run the command again using the standard WWN format, 16 hexadecimal digits grouped as eight
Action colon separated pairs. For example: 50:06:04:81:D6:F3:45:42.
Severity ERROR
SEC-1038
Message
<timestamp>, [SEC-1038], <sequence-number>,, ERROR, <system-name>, Invalid domain
<domain ID>
Probable Cause Indicates an invalid domain ID was entered.
Recommended Verify that the domain ID is correct. If it is not, then re-run the command using the correct domain
Action ID.
Severity ERROR
SEC-1040
Message
<timestamp>, [SEC-1040], <sequence-number>,, ERROR, <system-name>, Invalid
portlist (
Probable Cause Indicates the port list contains the wildcard asterisk (*) character. You cannot use the asterisk in a
port list.
Recommended Enter the port list values without any wildcards.
Action
510
is invalid due to a missing colon.
<invalid WWN>
.
.
<port list>
). Cannot combine * with port member in the same portlist.
Fabric OS Message Reference
53-1001767-01