Brocade Communications Systems 8 Reference page 593

Probable Cause Indicates the security database is corrupted for unknown reasons.
Recommended Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command
Action and contact your switch service provider.
Severity ERROR
SEC-1071
Message
<timestamp>, [SEC-1071], <sequence-number>,, ERROR, <system-name>, No new
security policy data to apply.
Probable Cause Indicates that no changes in the defined security policy database need to be activated at this time.
Recommended Verify that the security event was planned. First change some policy definitions, then run the
Action secPolicyActivate command to activate the policies.
Severity ERROR
SEC-1072
Message
<timestamp>, [SEC-1072], <sequence-number>,, ERROR, <system-name>,
type>
Probable Cause Indicates the specific policy type is empty. The security database is corrupted for unknown reasons.
Recommended Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command
Action and contact your switch service provider.
Severity ERROR
SEC-1073
Message
<timestamp>, [SEC-1073], <sequence-number>,, ERROR, <system-name>, No FCS policy
in list!
Probable Cause Indicates the specific policy type is empty. The security database is corrupted for unknown reasons.
Recommended Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command
Action and contact your switch service provider.
Severity ERROR
SEC-1074
Message
<timestamp>, [SEC-1074], <sequence-number>,, ERROR, <system-name>, Cannot execute
the command on this switch. Please check the secure mode and FCS status.
Fabric OS Message Reference
53-1001767-01
Policy List is Empty!
90
SEC-1071
<Policy
517