Brocade Communications Systems 8 Reference page 524

Fabric os message reference

Hide thumbs Also See for 8:

Table of Contents

Reduce the local device count to follow the capability of the lowest version of firmware.

<timestamp>, [NS-1004], <sequence-number>,, INFO, <system-name>, Number of local

devices <Current local device count>, exceeds the standby can support <Local

device count that standby can support>, can't sync.

Probable Cause

Indicates the name server on the standby CP has lower supported capability than the active CP

because of different firmware versions running on the active and standby CPs. This means that the

active and standby CPs are out of sync. Any execution of the haFailover or firmwareDownload

commands will be disruptive.

To avoid disruption of traffic in the event of an unplanned failover, schedule a firmwareDownload

so that the active and standby CPs have the same firmware version.

Reduce the local device count to follow the capability of the lowest version of firmware.

<timestamp>, [NS-1005], <sequence-number>,, WARNING, <system-name>, Zone size of

<Effective Zone Size> has over the supporting limit of <Support Zone Size> for the

remote switch domain ID <Remote Switch Domain ID>.

Probable Cause

Indicates the effective zone size has exceeded the limit that a remote switch can support. The

oversized portion will be truncated.

Reduce the zone size to 1024 or smaller, or upgrade the software of the remote switch to support

<timestamp>, [NS-1006], <sequence-number>,, WARNING, <system-name>, Duplicated

WWN was detected with PID <existing device PID> and <new device PID>.

Probable Cause

Indicates that an existing device has the same WWN as a new device that has come online.

The switch will process the new PID and leave the existing PID intact. Subsequent switch

operations will clean up the obsolete PID. However, administrators could check and remove devices

with a duplicated WWN.

Fabric OS Message Reference

53-1001767-01

Chapters

Table of Contents