Brocade Communications Systems 8 Reference page 359

Probable Cause Indicates that the Ethernet connection between the active control processor (CP) and standby CP is
not healthy. The error occurs when the standby CP does not respond to a request from the active
CP within five seconds. This usually indicates a problem with the internal Ethernet connection and
a disruption of the synchronization process.
Recommended Check the Ethernet connection between the active CP and standby CP (interface eth1) by issuing
Action net commands such as ifconfig eth1 (as root) or run supportShow/supportSave to validate the
network configuration; then try to restore the synchronization by issuing the haSyncStart
command. If the problem persists, contact your switch service provider.
Severity CRITICAL
FSS-1008
Message
<timestamp>, [FSS-1008], <sequence-number>, SLOT cp-slot-number | CHASSIS,
CRITICAL, <system-name>, FSS Error: <Error Message>.
Probable Cause Indicates that an error has occurred.
Recommended Run the supportSave command and contact your switch service provider.
Action
Severity CRITICAL
FSS-1009
Message
<timestamp>, [FSS-1009], <sequence-number>, SLOT cp-slot-number | CHASSIS, ERROR,
<system-name>, FSS Error: <Error Message>.
Probable Cause Indicates that an error has occurred.
Recommended Run the supportSave command and contact your switch service provider.
Action
Severity ERROR
FSS-1010
Message
<timestamp>, [FSS-1010], <sequence-number>, SLOT cp-slot-number | CHASSIS,
WARNING, <system-name>, FSS Warning: <Warning Message>.
Probable Cause Indicates that an error might have occurred.
Recommended No action is required.
Action
Severity WARNING
Fabric OS Message Reference
53-1001767-01
40
FSS-1008
283