Brocade Communications Systems 8 Reference page 419

Fabric os message reference

Hide thumbs Also See for 8:

Table of Contents

Replace the faulty or deteriorating fan field-replaceable units (FRUs).

<timestamp>, [FW-1432], <sequence-number>,, WARNING, <system-name>, Switch status

change contributing factor WWN:

Probable Cause

Indicates that the switch status is not in a healthy state. This occurred because the number of

faulty world wide name (WWN) cards is greater than or equal to the policy set by the

switchStatusPolicySet command.

Replace the faulty WWN card.

<timestamp>, [FW-1433], <sequence-number>,, WARNING, <system-name>, Switch status

change contributing factor CP: CP non-redundant.

Probable Cause

Indicates that the switch status is not in a healthy state. This occurred because the number of

faulty CPs is greater than or equal to the policy set by the switchStatusPolicySet command. The CPs

are non-redundant.

If you power cycle a Brocade 24000 chassis in dual-domain configuration, and then reset the

micro-switch of the active CP before the heartbeat is up, this will cause both CPs to come up in a

non-redundant state.

Run the firmwareShow command to verify that both CPs have compatible firmware levels. Run the

firmwareDownload command to install the same level of firmware to both CPs. Replace any faulty

If you reset the micro-switch (the latch on the CP blade) on the active CP before the heartbeat was

up on a power cycle, and the CPs came up non-redundant, then you should reboot the CPs again to

clear the problem.

<timestamp>, [FW-1434], <sequence-number>,, WARNING, <system-name>, Switch status

change contributing factor Blade:

Probable Cause

Indicates that the switch status is not in a healthy state. This occurred because the number of

blade failures is greater than or equal to the policy set by the switchStatusPolicySet command.

Fabric OS Message Reference

53-1001767-01

blade failures.

Chapters

Table of Contents