Brocade Communications Systems 8 Reference page 827

Fabric os message reference

Hide thumbs Also See for 8:

Table of Contents

AUDIT, <timestamp>, [SULB-1039], INFO, FIRMWARE, CP has completed relocating the

internal firmware image.

Probable Cause

Indicates that the firmwareDownload command process has been completed normally on the CP.

Run the firmwareShow command to verify the firmware versions.

AUDIT, <timestamp>, [SULB-1040], INFO, WARNING, An error has occurred during

relocation of the internal image on the CP.

Probable Cause

Indicates an error has occurred during the relocation of the internal image. The error may be

caused by inconsistent internal firmware image. It may also be caused by the internal Ethernet

Run the firmwareShow command to verify the firmware versions. Run the firmwareDownload

command again if the firmware is not updated.

This will cause the internal image to be relocated again. If the problem persists, contact your switch

service provider.

Fabric OS Message Reference

53-1001767-01

Chapters

Table of Contents