Brocade Communications Systems 8 Reference page 737

Probable Cause Indicates the fabric assist (FA) zoning configuration has more than one initiator. The probable
cause is incorrect entries in the FA zoning configuration.
Recommended Edit the zone database to ensure that only one initiator is set for each FA zone configuration.
Action
Severity ERROR
ZONE-1018
Message
<timestamp>, [ZONE-1018], <sequence-number>,, ERROR, <system-name>, Incorrect
zoning enforcement type(<zone type>) at port(<port number>).
Probable Cause Indicates an incorrect zoning enforcement type was reported on the specified port. This is a
software error. A QuickLoop zone type (value = 4) or an uninitialized type (value = 0) are invalid. The
valid zone type values are:
•
•
•
•
QuickLoop zones are not supported in Fabric OS v4.x and above.
Recommended If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
Action supportSave command and contact your switch service provider.
Severity ERROR
ZONE-1019
Message
<timestamp>, [ZONE-1019], <sequence-number>,, ERROR, <system-name>, Transaction
Commit failed. Reason code <reason code> (<Application reason>) - \"<reason
string>\"
Probable Cause Indicates the reliable commit service (RCS) had a transmit error. RCS is a protocol used to transmit
changes to the configuration database within a fabric.
Recommended Often this message indicates a transitory problem. Wait a few minutes and retry the command.
Action
Make sure your changes to the zone database are not overwriting the work of another admin.
Run the cfgTransShow command to find out if there is any outstanding transaction running on the
local switches.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
Fabric OS Message Reference
53-1001767-01
hard port zone (value = 1)
hard wwn zone (value = 2)
session based hard zoning (value = 3)
FA zone (value = 5)
111
ZONE-1018
661