Audit Sulb System Messages - Brocade Communications Systems 8 Reference

AUDIT SULB System Messages

SULB-1001
Message
AUDIT, <timestamp>, [SULB-1001], WARNING, FIRMWARE, <event-initiator-details>,
<event-location>, , Firmwaredownload command has started.
Probable Cause Indicates the firmwareDownload command has been started. This process should take
approximately 17 minutes. The process is set to time out after 30 minutes.
Recommended No action is required. Allow the firmwareDownload command to continue without disruption. Do
Action not fail over or power down the system during firmware upgrade.
Run the firmwareDownloadStatus command for more information.
Severity WARNING
SULB-1002
Message
AUDIT, <timestamp>, [SULB-1002], INFO, FIRMWARE, <event-initiator-details>,
<event-location>, , Firmwaredownload command has completed successfully.
Probable Cause Indicates the firmwareDownload command has completed successfully and switch firmware has
been updated.
Recommended No action is required. The firmwareDownload command has completed as expected.
Action
Run the firmwareDownloadStatus command for more information. Run the firmwareShow
command to verify the firmware versions.
Severity INFO
SULB-1003
Message
AUDIT, <timestamp>, [SULB-1003], INFO, FIRMWARE, <event-initiator-details>,
<event-location>, , Firmwarecommit has started.
Probable Cause Indicates that the firmwareCommit command has started.
Recommended No action is required. Run the firmwareDownloadStatus command for more information.
Action
Severity INFO
Fabric OS Message Reference
53-1001767-01
Chapter
128
739