Configuring NTP on the Switch
Disabling NTP
To disable NTP broadcast-client mode on the switch, perform this task in privileged mode:
Task
Step 1
Disable NTP broadcast-client mode.
Step 2
Verify the NTP configuration.
This example shows how to disable NTP broadcast-client mode on the switch:
Console> (enable) set ntp broadcastclient disable
NTP Broadcast Client mode disabled
Console> (enable)
To disable NTP client mode on the switch, perform this task in privileged mode:
Task
Step 1
Disable NTP client mode.
Step 2
Verify the NTP configuration.
This example shows how to disable NTP client mode on the switch:
Console> (enable) set ntp client disable
NTP Client mode disabled
Console> (enable)
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
39-8
Chapter 39
Command
set ntp broadcastclient disable
show ntp [noalias]
Command
set ntp client disable
show ntp [noalias]
Configuring NTP
78-15908-01