Disabling Ntp - Cisco WS-C4003 - Catalyst 4000 Chassis Switch Software Configuration Manual

Configuring NTP

Disabling NTP

To disable NTP broadcast-client mode on the switch, perform this task in privileged mode:
Task
Step 1
Disable NTP broadcast-client mode.
Step 2
Verify the NTP configuration.
This example shows how to disable NTP client mode on the switch:
Console> (enable) set ntp broadcastclient disable
NTP Broadcast Client mode disabled
Console> (enable)
To disable NTP client mode on the switch, perform this task in privileged mode:
Task
Step 1 Disable NTP client mode.
Step 2 Verify the NTP configuration.
This example shows how to disable NTP client mode on the switch:
Console> (enable) set ntp client disable
NTP Client mode disabled
Console> (enable)
Software Configuration Guide—Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4
35-8
Chapter 35
Command
set ntp broadcastclient disable
show ntp [noalias]
Command
set ntp client disable
show ntp [noalias]
Configuring NTP
78-12647-02