Configuring Tacacs+ Login Authentication - Cisco WS-C3550-12G Software Configuration Manual

Controlling Switch Access with TACACS+
Beginning in privileged EXEC mode, follow these steps to identify the IP host or host maintaining
TACACS+ server and optionally set the encryption key:
Command
Step 1 configure terminal
Step 2
tacacs-server host hostname [port
integer] [timeout integer] [key string]
Step 3 aaa new-model
Step 4 aaa group server tacacs+ group-name
Step 5
server ip-address
Step 6
end
Step 7 show tacacs
Step 8
copy running-config startup-config
To remove the specified TACACS+ server name or address, use the no tacacs-server host hostname
global configuration command. To remove a server group from the configuration list, use the no aaa
group server tacacs+ group-name global configuration command. To remove the IP address of a
TACACS+ server, use the no server ip-address server group subconfiguration command.

Configuring TACACS+ Login Authentication

To configure AAA authentication, you define a named list of authentication methods and then apply that
list to various interfaces. The method list defines the types of authentication to be performed and the
sequence in which they are performed; it must be applied to a specific interface before any of the defined
authentication methods are performed. The only exception is the default method list (which, by
coincidence, is named default). The default method list is automatically applied to all interfaces except
those that have a named method list explicitly defined. A defined method list overrides the default
method list.
Catalyst 3550 Multilayer Switch Software Configuration Guide
6-14
Purpose
Enter global configuration mode.
Identify the IP host or hosts maintaining a TACACS+ server. Enter this
command multiple times to create a list of preferred hosts. The software
searches for hosts in the order in which you specify them.
For hostname, specify the name or IP address of the host.
•
• (Optional) For port integer, specify a server port number. The default
is port 49. The range is 1 to 65535.
• (Optional) For timeout integer, specify a time in seconds the switch
waits for a response from the daemon before it times out and declares
an error. The default is 5 seconds. The range is 1 to 1000 seconds.
(Optional) For key string, specify the encryption key for encrypting
•
and decrypting all traffic between the switch and the TACACS+
daemon. You must configure the same key on the TACACS+ daemon
for encryption to be successful.
Enable AAA.
(Optional) Define the AAA server-group with a group name.
This command puts the switch in a server group subconfiguration mode.
(Optional) Associate a particular TACACS+ server with the defined
server group. Repeat this step for each TACACS+ server in the AAA
server group.
Each server in the group must be previously defined in Step 2.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 6 Administering the Switch
78-11194-03