Show Arp Filter - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show arp filter

Displays a list of ARP filters configured for the switch.
show arp filter [ip_address]
Syntax Definitions
ip_address
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
If an IP address is not specified with this command, a list of all ARP filters is displayed.
•
Enter a specific IP address to view the configuration for an individual filter.
Examples
-> show arp filter
IP Addr
-----------------+-------------------+------+----------+-------
171.11.1.1
172.0.0.0
198.0.0.0
198.172.16.1
-> show arp filter 198.172.16.1
IP Addr
-----------------+-------------------+------+----------+-------
198.0.0.0
198.172.16.1
output definitions
IP Addr
IP Mask
Vlan
Type
Mode
page 14-136
IP address of the filter entry you want to view.
IP Mask
255.255.255.255
255.0.0.0
255.0.0.0
255.255.255.255
IP Mask
255.0.0.0
255.255.255.255
The ARP packet IP address to which the filter is applied.
The IP mask that specifies which part of the IP address to which the fil-
ter is applied.
A VLAN ID. The filter is applied only to ARP packets received on
ports associated with this VLAN.
Indicates which IP address in the ARP packet (sender or target) is
used to identify if a filter exists for that address.
Indicates whether or not to block or allow a switch response to an ARP
packet that matches the filter.
Vlan Type Mode
0 target block
0 target block
0 sender block
200 target allow
Vlan Type Mode
0 sender block
200 target allow
OmniSwitch CLI Reference Guide
IP Commands
June 2012