Conductix-Wampfler ProfiDAT compact Mounting Instructions page 21

Mounting Instructions
ProfiDAT compact
®
Data Transmission System
Program 0515
External influences on
electrical equipment due to
external interference
sources!
2.9.6 Emergency stop
The ProfiDAT compact Data Transmission System does not have its own emergency stop. Suitable safety components must be
®
incorporated to ensure the emergency stop function.
Conductix-Wampfler recommends the use of a PROFIsafe system.
2.9.7 Danger zones
WARNING!
WARNING!
MAL0515-0001i-EN
www.conductix.com
External interference sources, such as radio or radar, can cause faults in the components and
the WLAN network.
→ Only use the manufacturer's data rail (slotted waveguide).
Risk of injury due to moving components!
When the system is operating, severe injuries can result if persons or objects are within the
movement range (danger zone!).
→ Do not operate the machine if persons or objects are within the range of motion (danger
zone!).
Exception: Repair and maintenance work. The machine may only be run at a
reduced speed and with extreme care.
→ Ensure that the machine cannot move in an uncontrolled manner.
→ Do not reach into moving parts.
→ Cordon off the danger zone around the entire system.
Risk of death due to suspended loads!
Falling or uncontrolled swinging loads can lead to severe injury or even death.
→ Never walk under suspended loads.
→ Only use authorized lifting gear and lashing components with sufficient load capacity.
→ Ensure that lashing components are properly seated.
→ Do not use torn or worn ropes or straps.
→ Do not attach ropes or straps to sharp corners and edges and do not knot or twist them.
→ Only move loads under supervision.
→ Set down the load before leaving the work area.
Translated from MAL0515-0001k-DE Page 21 of 169