Conductix-Wampfler ProfiDAT compact Mounting Instructions page 165

Mounting Instructions
ProfiDAT compact
®
Data Transmission System
Program 0515
10 Disassembly and Disposal
10.1 Safety
WARNING!
10.2 Disassembly
After the end of its service life, the data transmission system must be disassembled and disposed of in an environmentally friendly
manner.
→ Remove operating and auxiliary materials, as well as residual processing materials, and dispose of them in an environmentally
appropriate manner.
WARNING!
→ Clean the assemblies and components properly and disassembly and dispose of them in compliance with locally applicable
occupational safety and environmental protection regulations.
MAL0515-0001i-EN
www.conductix.com
Risk of injury due to improper disassembly!
Stored residual energy, sharp components, points and edges on and in the data transmission
system or the tools needed can cause injuries.
→ Ensure sufficient space before starting work.
→ Use caution when working with open, sharp-edged components.
→ Ensure that the work area is tidy and clean! Loosely stacked or scattered components and
tools are a source of accidents.
→ Disassemble components properly. Observe the high dead weight some components. Use
lifting gear, if necessary.
→ Secure components so they cannot fall or topple over.
→ Consult the manufacturer in case of doubt.
Observe the dangers due to electrical shock, harmful dusts, sharp edges and moving
parts!
Translated from MAL0515-0001k-DE Page 165 of 169