Figure 25: Rtp Session Information; Figure 26: Line Monitor Information - Nortel BCM50 Release 3.0 SIP Configuration Manual

The BCM Monitor can be used to monitor incoming and outgoing trunks to
determine if trunks are being busy or if they are idle. The example below depicts
utilized lines used by local and remote telephone/DN numbers.
The BCM Monitor can also be used to monitor all types of system usages. The
following are some parameters that can be monitored:
• CPU utilization
• Physical memory
• Media card DSP utilization
• IP sets and IP Trunks
• Voice ports and media gateway usage
© 2007 AT&T Intellectual Property. All rights reserved. AT&T, the AT&T
logo and all other AT&T marks contained herein are trademarks of AT&T
Intellectual Property and/or AT&T affiliated companies.
marks contained herein are the property of their respective owners.
AT&T IP Flexible Reach Service
Nortel BCM50 Release 3.0 SIP Configuration Guide

Figure 25: RTP Session Information

Figure 26: Line Monitor Information

Issue 0.7
All other
Page 32 of 37