Isuzu Tilt Slide FYJ2000 Instruction Manual page 565

Relays
Fuses
Normal Open
IN CASE OF EMERGENCY
Replacing the Fuses
1. Before replacing fuses, be sure to
place the starter switch in the "LOCK"
position and pull back on the parking
brake lever.
2. Place the fuse puller on the fuse and
pull it out. (The fuse puller is stored in
the fuse box in the cab.)
3. If the fuse appears as shown in the
right hand side of the diagram at
left, the fuse is blown. Replace with
a spare fuse. (The spare fuses are
stored in the fuse box in the cab.)
WARNING
• Use fuses of the same rating for
replacement. Do not use any fuses
MFU780SH005901
other than those designated.
• Using fuses other than those
specified could result in fire or
damage to equipment.
• If the new fuses blow right away,
contact the nearest Isuzu Dealer.
Changing Relays
Before replacing relays, remove the cover.
MFU8Z0SH080001
• It is not necessary to open or close
the cover unless trouble is found.
• The relay box structure makes it
difficult for water to enter. If you
should spill water or a beverage
on the cover, however, wipe it off
before opening the cover.
• The area around the cover will get
warm when the vehicle is being
driven, but this is not abnormal.
ADVICE
8-37