Isuzu Tilt Slide FYJ2000 Instruction Manual page 539

Sequence for connecting cable
Sequence for removing cable
ADVICE
• When it is difficult to start the engine in a cold area, first start the engine of the
vehicle with the booster battery and after that start the engine of the disabled
vehicle.
IN CASE OF EMERGENCY
When the Battery Goes Flat
If the vehicle battery goes flat and you try
to start the engine with a booster cable,
use the following methods.
Checking the Battery Fluid Level
1. Stop the engine of the vehicle with the
booster battery.
2. Check the battery fluid level in the
disabled vehicle.
→ Refer to page 7-144
3. Connect one end of the red booster
cable to the positive battery terminal
(1) of the disabled vehicle and the
other end of the cable to the positive
battery terminal (2) of the vehicle with
the booster battery.
4. Connect one end of the black booster
cable to the negative battery terminal
(3) of the vehicle with the booster
battery and the other end to the frame
of the disabled vehicle (4), as far
away from the battery as possible.
5. After connecting the cables, start the
engine of the disabled vehicle.
6. If the engine in the disabled vehicle
starts, remove the booster cables in
the reverse sequence as they were
connected.
8-11