Isuzu Tilt Slide FYJ2000 Instruction Manual page 496

7-168
SERVICE AND MAINTENANCE
MAINTENANCE SCHEDULE UNDER SEVERE OPERATING CONDITIONS
A: Repeated short trips with extensive idling and/or where the engine does not reach normal operating
temperature. Also applications involving descending or ascending steep gradients. (Examples may
be Concrete Agitators, Tow trucks, Concrete Pumpers, Road Patchers, mine site trucks etc)
B: Driving on rough/loose surface roads (More than 10% of operation) or operating in any harsh
environment/application likely to cause accelerated wear and tear. (Examples may be Tippers travelling
in and out of quarries, Logging trucks, Farm trucks, trucks that run on poorly made rural roads, Trucks
involved in the mining industry etc)
C: Driving on dusty/muddy or corrugated roads. (Examples may be Mine site trucks, 4WD bus
conversions, Emergency Service trucks, Drill rigs etc)
D: Driving in extremely cold and/or hot weather. (Less than 0 Deg. C or greater than 40 Deg. C)
Engine oil
Engine oil filters
Fuel filters
Air filter elements
Manual transmission oil
Automatic transmission oil and filter
Differential oil
Power steering fluid
Front & rear wheel bearing
grease/oil
Exhaust pipes & mounting, exhaust
brake operation
Perform manual regeneration,
check exhaust pressure and clean
DPD filter if required
All grease points
Grease king pins
Item
Change every 10,000 km
(200hrs)
Replace every 10,000 km
(200hrs)
Replace every 10,000 km
(200hrs)
Inspect every 5,000 km
(100hrs) and replace as
required
Change every 40,000 km
(800hrs)
Change every 40,000 km
(800hrs)
Change every 40,000 km
(800hrs)
Change every 40,000 km
(800hrs)
Change every 40,000 km
(800hrs)
Inspect every 10,000 km
(200hrs)
Inspect every 40,000 km
(800hrs)
Grease every 5,000 km
(100hrs)
Grease every 5,000 km
(100hrs)
Interval
A
*
*
*
*
*
*
*
*
*
Condition
B C D
* *
* *
* *
* *
* * *
* * *
* * *
* * *
* * *
* *
* *
* * *
* * *