Isuzu Tilt Slide FYJ2000 Instruction Manual page 141

NOTE
• Make a habit of filling up the fuel tank well before it approaches empty.
• After filling up the fuel tank, it takes a while for the fuel gauge needle to stabilize
after the starter switch is turned to the "ON" position.
• If the fuel tank is filled with the engine stopped but the starter switch in the "ON"
position, the fuel gauge needle takes a while to show the correct reading. If
so, turn the starter switch to the "LOCK" position and then to the "ON" position
again.
CONTROLS AND INSTRUMENTS
Fuel Gauge
With the starter switch in the "ON" position,
this gauge indicates the quantity of fuel
remaining in the fuel tank. "F" means the
tank is full while "E" means the tank is
almost empty.
Low Fuel Warning Light
When the Fuel Runs Out
Hour Meter
This meter indicates how many hours the
engine has been running.
The figure(s) on the left side of the decimal
point indicates hour(s) while the figure on
the right side indicates 1/10 of an hour.
This is displayed on the multi-information
display (MID).
To display the hour meter, press the MID
select knob.
When ERROR is Displayed
→ Refer to page 4-43
→ Refer to page 8-13
→ Refer to page 4-28
4-13