Isuzu Tilt Slide FYJ2000 Instruction Manual page 463

Jack handle
SERVICE AND MAINTENANCE
2. Turn the head of the jack to extend it
to the height of the jacking point. Turn
it counterclockwise to extend.
3. Insert the jack handle into the socket.
When jacking up the vehicle, use the
notched part of the jack handle and
turn the release valve fully clockwise.
4. Move the jack handle gently up and
down to extend it slightly.
5. Confirm that the jack is in good
HCU7C0SH010201
contact with the jacking point, and
then continue to raise the vehicle.
Lowering the Vehicle
1. Line up the jack handle end notch
with the release valve.
2. Gently turn the release valve
counterclockwise to lower the jack.
3. When the jack is completely lowered,
turn the release valve fully clockwise.
• Do not abruptly stop the jack while
lowering the vehicle. Doing so may
damage the jack.
4. Turn the jack head fully clockwise.
ADVICE
7-135