Isuzu Tilt Slide FYJ2000 Instruction Manual page 404

7-76
SERVICE AND MAINTENANCE
Wheel nut tightening sequence
ADVICE
• After changing a tyre, turn the steering wheel in both directions to make sure
that the wheels do not interfere with the surrounding components. If you are not
sure about this, please contact the nearest Isuzu Dealer.
• Tightening torque of the wheel nuts may decrease after tyre replacement due
to their initial settlement. Upon driving 50 to 100 km (31 to 62 miles) after tyre
replacement, retighten the wheel nuts to the specified torque according to the
instructions in the "Retightening Wheel Nuts" section in this chapter.
7. Turn the bleeder screw of the jack
counterclockwise to lower the vehicle
slowly.
8. Tighten the wheel nuts in a diagonal
sequence and in two or three passes.
When installing the rear wheel, tighten
the nuts of the inner wheel first and
then the nuts of the outer wheel.
9. Finally tighten all wheel nuts using a
torque wrench to the specified torque.
You must tighten the nuts of the rear
inner wheel before tightening the nuts
of the rear outer wheel even when
you change only the rear outer wheel.
Wheel nut tightening torque
550 - 600 N·m
(55 - 60 kgf·m/398 - 434 lb·ft) (wet)
Retightening Wheel Nuts (JIS 8-bolt
Wheels) → Refer to page 7-77