Isuzu Tilt Slide FYJ2000 Instruction Manual page 158

4-30
CONTROLS AND INSTRUMENTS
CAUTION
• If this warning light comes on while driving, immediately pull off to a safe place
well clear of traffic and take the following actions.
- Stop the engine.
- Restart the engine. Check if the ABS warning light comes on and then goes
out. If it does, there is no problem. The ABS operates normally.
• If the warning light does not go out, or comes on repeatedly, have the vehicle
inspected / serviced at the nearest Isuzu Dealer as soon as possible.
• If the ABS has a problem, the brakes still function normally as ordinary service
brakes. However, the ABS functions are no longer available.
Air Pressure Warning Light
This warning light should normally come
on when the starter switch is turned to the
"ON" position, and then should go out after
the engine has started.
This warning light comes on and a buzzer
sounds if air pressure drops below the
specified level. (The buzzer will go off while
the parking brake is applied.) Immediately
pull off to a safe place, check the vehicle
and take necessary actions.
Air Pressure Gauge
ABS Warning Light
This warning light should come on when
the starter switch is turned to the "ON"
position, and then should go out after
approximately 2 seconds.
This warning light comes on when the
antilock brake system (ABS) has a problem.
In this case, the ABS stops working but
the brakes still function as ordinary service
brakes.
Antilock Brake System (ABS)
→ Refer to page 4-11
→ Refer to page 4-94