Isuzu Tilt Slide FYJ2000 Instruction Manual page 215

CAUTION
Shifting to Lo-Lo
• A shift to Lo-Lo is possible only with the following steps:
- Shift from "N" to "Lo-Lo" with the vehicle completely stationary.
- Shift from "Lo" to "Lo-Lo".
Shifting to Lo
• A shift to Lo is possible only with the following steps:
- Shift from "N" to "Lo" with the vehicle completely stationary.
- Shift from "1st" to "Lo".
- Shift from "Lo-Lo" to "Lo".
Shifting to Rev. Lo-Lo
• A shift to Rev. Lo-Lo is possible only with the following step:
- Shift from "N" to "Rev. Lo-Lo" with the vehicle completely stationary.
Shifting to Rev. Lo
• A shift to Rev. Lo is possible only with the following step:
- Shift from "N" to "Rev. Lo" with the vehicle completely stationary.
Shifting to Rev. Hi
• A shift to Rev. Hi is possible only with the following step:
- Shift from "N" to "Rev. Hi" with the vehicle completely stationary.
• If your vehicle has a back-up warning buzzer, make sure you hear the buzzer
sounding outside after placing the gearshift lever in the "R" (reverse) position.
If you cannot hear the buzzer, the reverse gear is not engaged and the vehicle
may roll on a downhill slope. In such a situation, you must move the gearshift
lever back to the neutral position and then move it again to the "R" position.
• Always fully depress the clutch pedal before moving the gearshift lever.
• If you cannot make a range change
- If you cannot shift from "Lo" to "Hi", the vehicle can still be driven. Promptly
contact the nearest Isuzu Dealer to have the vehicle inspected.
- If you cannot shift from "Hi" to "Lo", the vehicle cannot be driven. Immediately
stop the vehicle in a safe place and contact the nearest Isuzu Dealer.
CONTROLS AND INSTRUMENTS
4-87