Isuzu Tilt Slide FYJ2000 Instruction Manual page 209

CAUTION
• You may shift into "C (crawler)" only when starting the vehicle from a
standstill. Shifting into the "C" position during driving will cause damage to the
transmission.
• Shift into "C (crawler)" or "R (reverse)" only when the vehicle has come to a
stop completely. Doing otherwise may cause damage to the transmission.
Shift into the reverse gear from a forward gear or vice versa only after bringing
the vehicle to a complete stop. Doing otherwise may damage the transmission.
• Fully depress the clutch pedal before operating the gearshift lever.
ADVICE
• Use the "C (crawler)" position when you need powerful driving forces such as
when the vehicle is loaded.
• Use the 1st gear for normal starting.
Low range indicator light
CONTROLS AND INSTRUMENTS
How to Use the Low-high Range
Selector Switch (Single-H Shift
Pattern Model)
Before shifting up from "4 (4th gear)" to
"5 (5th gear)" or shifting down from "5
(5th gear)" to "4 (4th gear)", you need to
operate the low-high range selector switch.
1. Set the selector switch to the low
range or the high range position.
2. Fully depress the clutch pedal.
3. Place the gearshift lever into the
"N" position. When switching to the
high range is completed, the low
range indicator light goes out. When
the switching to the low range is
completed, the low range indicator
light comes on.
• The low-high range switching starts
taking place only when the gearshift
lever is placed in "N".
NOTE
4-81