Isuzu Tilt Slide FYJ2000 Instruction Manual page 214

4-86
CONTROLS AND INSTRUMENTS
Lo to Lo-Lo...
5. DO NOT downshift into Lo-Lo from Lo unless operating conditions make it
necessary. Lo-Lo can be obtained with the transmission in Lo range and the
shift lever in the Lo speed gear position by moving the deep reduction selector
to the "In" position. Then immediately release the accelerator pedal, depress
the clutch pedal once to break torque, re-engage the clutch and accelerate. The
transmission shifts from Lo to Lo-Lo when synchronous is reached.
Downshift Procedure
1. Move the shift lever, double-clutching,
to the next desired gear position in HI
range.
Range shift from HI Range to Lo
Range (5th to 4th)...
2. While in 5th and ready for the next
downshift, preselect Lo range, push
the range preselection lever down.
3. Move the shift lever, double-clutching,
to the next desired gear position in
Lo range. As the shift lever passes
through neutral, the transmission
automatically shifts from Hi range to
Lo range.
4. Continue downshifting, double-
clutching, to the next desired gear
position in Lo range.