Isuzu Tilt Slide FYJ2000 Instruction Manual page 132

4-4
CONTROLS AND INSTRUMENTS
Make sure that the switches, including those for the windshield wiper, light control and
air conditioner, are in the "OFF" position.
Turn the starter switch to the "ON" position to check that the warning and indicator
lights turn on normally and the fuel level is proper.
ADVICE
• Using a key sticking with dirt or dust, etc. may possibly damage the starter
switch. Make sure to wipe off any dirt or dust, etc. before inserting the key.
CAUTION
• Firmly engage the parking brake when you sit in the seat before starting the
engine. Also, be sure to start the engine while pressing the clutch pedal and
after making sure that the gearshift lever is in "N".
• It is dangerous to start the engine from outside through the window. If the
gearshift lever is not in "N", your vehicle may start moving. Never start the
engine in that way.
Starting the Engine
Starting the Engine
• Do not keep the starter switch in
the "START" position for more than
about 10 seconds. Operating the
starter for too long might cause
battery failure or might result in
overheating and even a fire.
Starter Switch→ Refer to page 4-52
1. Fully press the clutch pedal.
2. Turn the starter switch to the "START"
position to start the engine.
WARNING