Isuzu Tilt Slide FYJ2000 Instruction Manual page 357

Center bolt
Partial oil filter
drain plug
SERVICE AND MAINTENANCE
Partial Oil Filter
1. Remove the oil filler cap. Remove the
oil filter drain plug to discharge the oil
into the container.
2. Loosen the center bolt, and remove
the element together with the filter
body.
3. Wash the inside of the filter body, and
install a new element. Also, replace
the O-rings.
4. Tighten the drain plug and the center
bolt to the specified torque.
Center bolt tightening torque
95 - 105 N·m (9.7 - 10.7 kgf·m/70 - 77 lb·ft)
HCU7C0SH004601
Partial oil filter drain plug tightening torque
25 - 35 N·m (2.6 - 3.6 kgf·m/19 - 26 lb·ft)
• When installing the filter body, hold it
down to prevent it from turning, and
tighten the center bolt. If the filter
body turns, the O-ring may become
damaged, resulting in oil leakage.
• After changing the oil filter, operate
the engine to check that there are
no leaks around the filter.
ADVICE
7-29