Isuzu Tilt Slide FYJ2000 Instruction Manual page 436

7-108
SERVICE AND MAINTENANCE
Changing the Transmission Oil
(ZF9S1310 Model Transmission)
Transmission oil must be changed at the
specified intervals.
1. Place a container under the drain plug
to receive oil.
2. Remove the oil level plug and then
the drain plugs 1 and 2 to discharge
the oil into the container.
3. Install the drain plugs 1 and 2 to their
specified torques.
Thoroughly wipe clean the drain plug
2 before installing it.
4. Refill the transmission with new oil up
to the lower edge of level check plug
hole. After refilling, confirm that the oil
level is up to the lower edge of the oil
level plug hole.
5. Install the oil level plug to the
specified torque.
Plug tightening torque
Oil level plug
Drain plug 1
Drain plug 2
ADVICE
• The dirt on the plug should be wiped
off before removing or installing it.
NOTE
• The transmission model and model
code are indicated on the ID plate in
the cab.
60 N·m
(6.1 kgf·m/44 lb·ft)
120 N·m
(12.2 kgf·m/88 lb·ft)