Isuzu Tilt Slide FYJ2000 Instruction Manual page 210

4-82
CONTROLS AND INSTRUMENTS
CAUTION
• Fully depress the clutch pedal before operating the gearshift lever.
• Do not change to the low range at 30 km/h (19 MPH) or higher speeds. Doing
so may cause a failure in the transmission.
• Operate the selector switch immediately before the gear change operation.
If the selector switch is operated too early, gear shifting does not take place
correctly and the transmission may be damaged.
NOTE
• If low-high range switching becomes impossible
- If low-to-high range switching is impossible, you can still drive the vehicle.
Have your vehicle inspected at the nearest Isuzu Dealer promptly.
- If high-to-low range switching becomes impossible, you cannot drive the
vehicle. Immediately stop your vehicle at a safe place and contact the nearest
Isuzu Dealer.
• If the vehicle speed exceeds approximately 17 km/h (11 MPH) while the low
range is being used, shifting from "3 (3rd)" or "4 (4th)" to "1 (1st)", "2 (2nd)",
"C1 (crawler 1)" or "R1 (reverse 1)" is prevented from taking place. (The gate
interlock mechanism works.)
• If the vehicle speed exceeds approx. 30 km/h (19 MPH) while the high range is
being used, switching from the high range to the low range is prevented from
taking place. (The range interlock mechanism works.)
4. When shifting up from "4 (4th)" to
"5 (5th)", check that the indicator
light remains off and then place
the gearshift lever into the "1 (1st)"
position. Move the gearshift lever from
"5 (5th gear)" to "8 (8th gear)" with the
selector switch left in the high range
position.
When shifting down from "5 (5th)" to
"4 (4th)", check that the low range
indicator light is on and then place
the gearshift lever into the "4 (4th)"
position.