Isuzu Tilt Slide FYJ2000 Instruction Manual page 356

7-28
SERVICE AND MAINTENANCE
Main oil filter
drain plug
Changing the Oil Filter
Main Oil Filter
Center bolt
HCU7C0SH004401
1. Remove the oil filler cap. Remove the
oil filter drain plug to discharge the oil
into the container.
2. Loosen the center bolt, and remove
the element together with the filter
body.
3. Wash the inside of the filter body, and
install a new element. Also, replace
the O-rings.
4. Tighten the drain plug and the center
bolt to the specified torque.
Center bolt tightening torque
45 - 55 N·m (4.6 - 5.6 kgf·m/33 - 41 lb·ft)
Main oil filter drain plug tightening torque
40 - 50 N·m (4.1 - 5.1 kgf·m/30 - 37 lb·ft)
ADVICE
• When installing the filter body, hold it
down to prevent it from turning, and
tighten the center bolt. If the filter
body turns, the O-ring may become
damaged, resulting in oil leakage.
• After changing the oil filter, operate
the engine to check that there are
no leaks around the filter.