Isuzu Tilt Slide FYJ2000 Instruction Manual page 558

8-30
IN CASE OF EMERGENCY
Locked
Replacing the Turn Signal Lights
MFU9Z0SH001501
Socket
MFU780SH005301
3. Pull off the bulb from the clearance
light socket and replace with a new
one.
4. To install the lights, perform the same
sequence of operations in reverse
taking care of the following point:
• Turn the connector clockwise to
securely lock it.
ADVICE
• If the connector is not locked
securely, water could get inside the
light and lead to a breakdown.
1. Remove the socket from the
rear of the bumper by turning it
counterclockwise.
2. Pull off the bulb from the socket and
replace with a new one.
3. To install the lights, perform the same
sequence of operations in reverse
taking care of the following points:
• Turn the socket clockwise to
securely lock it.
ADVICE
• If the socket is not locked securely,
water could get inside the light and
lead to a breakdown.