Isuzu Tilt Slide FYJ2000 Instruction Manual page 399

WARNING
• Before jacking up the vehicle, make sure to apply the parking brake firmly and
fully chock the specified wheel. Applying only the parking brake is insufficient to
prevent the vehicle from moving. When a rear wheel is jacked up, the vehicle
blocked only by the parking brake would move, creating a very dangerous
situation.
• Never open doors or start the engine while jacking up the wheel. Do not try to
look into the underside of the vehicle or get beneath the vehicle. This is very
dangerous.
• To avoid danger in case of the jack slipping off, place the removed spare tyre
near the jack under the vehicle.
CAUTION
• The wheel is heavy. Carefully handle it to avoid getting hurt when removing and
installing the wheel.
• Do not to touch the exhaust pipe just after stopping the vehicle; it is very hot.
SERVICE AND MAINTENANCE
Removing a Wheel
1. Firmly apply the parking brake. When
changing a front wheel, chock the rear
wheel diagonally opposite to the front
wheel. When changing a rear wheel,
chock the front wheel diagonally
opposite to the front wheel.
2. Apply the head of the jack to the
jacking point firmly.
3. Raise the vehicle enough so that the
tire is not quite clear of the ground.
4. Using the wheel bolt wrench, loosen
the wheel nuts just enough so that the
wheel remains stable in position. Do
not remove the wheel nuts yet.
• Do not loosen the wheel nuts too
much. The wheel bolts would be
damaged.
CAUTION
7-71