Isuzu Tilt Slide FYJ2000 Instruction Manual page 444

7-116
SERVICE AND MAINTENANCE
Replacing the Oil Filter
RT40 Type Axle
V
1. Turn the old oil filter to remove it.
2. Apply oil to the seal ring.
3. Install the new oil filter by turning it
until it comes in contact with the seal
ring.
4. Tighten the oil filter by turning it a
further three quarters (3/4) of a turn.
5. Start the engine and let it warm up.
6. Check the area around the filter for
any oil leaks.
CAUTION
• Use only an Isuzu genuine oil filter.
Any other oil filter has a projection,
which will interfere with the carrier
before the filter comes in contact
with the seal. This will result in a
serious oil leakage problem.