Isuzu Tilt Slide FYJ2000 Instruction Manual page 140

4-12
CONTROLS AND INSTRUMENTS
Engine overheat warning light
Engine Coolant Temperature Gauge
With the starter switch in the "ON" position,
this gauge indicates the temperature of
the engine coolant. "C" means cold while
"H" means hot. If the engine overheats,
the warning message is indicated and a
warning buzzer sounds. During operation,
the needle should stay in the safety zone.
ADVICE
• If the needle goes up above the
upper limit of the safety zone and
enters the "H" zone while you
are driving, the engine is likely to
overheat. Immediately pull safely off
the road out of the way of any traffic
and take necessary actions to deal
with engine overheating.
• If the needle nears the "H" zone
but is still in the safety zone, this
is not a problem. But, check the
engine coolant level in the radiator
sub-tank. Add engine coolant up as
required.
• The engine can seize up if it is
stopped immediately after driving.
Take appropriate actions for engine
overheating.
Engine Coolant → Refer to page 7-38
When the Engine Overheats
→ Refer to page 8-19