Isuzu Tilt Slide FYJ2000 Instruction Manual page 403

Outside tire air valve
Inside tire air valve
SERVICE AND MAINTENANCE
CAUTION
• Do not use oils that contain
molybdenum disulfide. When
tightened to the same torque, the
bolts and nuts coated with these oils
produce a grip force much larger
than those coated with other oils.
Too much grip force could cause
wheel bolts to be broken.
• Some impact wrenches available
in the market produce a torque
higher than the maximum torque
specified for tightening the wheel
nuts. If the wheel nuts are tightened
with such an impact wrench, wheel
bolts might be broken. Before using
an impact wrench, check that the
torque it produces conforms to the
specification.
• When using an impact wrench,
carefully adjust the air pressure
regulator and select the tightening
time. It is recommended to use a
torque wrench for final tightening
to be able to tighten nuts to the
specified torque.
5. Install the wheel while aligning the
bolt holes in the disc wheel with the
wheel bolts.
When installing the rear wheel, place
the outer wheel so that its tire air
valve will be 180 degrees apart from
that of the inner wheel to enable
inflating both tires.
6. Screw in each wheel nut by hand until
it touches the nut seating surface on
the disc wheel, and then finger tighten
all wheel nuts until the wheel is held
in position.
Face the tapered end of each wheel
HCU7C0SH011601
nut inward.
7-75