Isuzu Tilt Slide FYJ2000 Instruction Manual page 427

ADVICE
• Release the clutch pedal carefully to prevent the vehicle from starting too
suddenly.
Adjustment of Clutch Pedal Free Play
Clutch shaft
Push rod
Clutch booster
SERVICE AND MAINTENANCE
Adjustment of Clutch Booster
(MJT7 Model Transmission)
If the free play of the clutch pedal is
not within the specified range, make
adjustments at the clutch booster and the
clutch master cylinder with the engine
stopped.
Lock nut
HCU7C0SH009401
ADVICE
• Vehicles with transmission model
ZF9S1310 or RTO-11908LL do not
require clutch booster adjustment.
1. Remove the return spring from the
clutch booster.
2. Loosen the push rod lock nut.
3. Turn and extend the push rod until it
becomes stiff.
4. From this point, turn the push rod
back the number of turns indicated in
the table below.
Number of turns
2 1/2 to 3
5. Tighten the lock nut firmly and install
the return spring.
6. Check the free play of the clutch
pedal. If the free play is not up to
the specification, continue with the
following steps to make another
adjustment at the master cylinder.
7-99